Rep 91.8 Upper Carriage Drive Shaft, Cranks, Upper Front And Rear Compliant Links - Xerox ColorQube 9303 Series Service Manual

Replacement
1. Replacement is the reverse of the removal procedure.
2. Ensure all ground lead connections are firmly remade.
3. When installing a new carriage, ensure the shipping restraint clips are removed before
installation, Figure 5.
1
Remove both shipping
restraint clips.
Figure 5 Shipping restraint clips
4. Ensure the harnesses are routed correctly, refer to
5. Run the relevant diagnostic routines, refer to
6. Ensure that both carriages are parked and the wiper is in the home position, all the way
up or down.
Repairs/Adjustments
REP 91.7, REP 91.8
GP 28.
GP 37 Post Part Replacement Routines.
February 2013
REP 91.8 Upper Carriage Drive Shaft, Cranks, Upper Front
and Rear Compliant Links
Parts List on PL 91.10
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Do not touch the exposed face of the printheads. Surface contamination or minor damage can
destroy the printhead.
1. Remove marking unit upper printheads,
2. Remove marking unit upper carriage,
3. Remove marking unit upper drive gear,
Figure 1 Drive gear removal
4-332
WARNING
GP 14. Disconnect the power cord
WARNING
CAUTION
REP 91.29.
REP 91.7.
Figure 1.
1
Remove the screw
then the drive gear.
ColorQube® 9303 Family