Rep 13.29 Front/Rear Carriage Assembly - Xerox VersaLink B7025 Service Manual

4. Remove the compiler no paper sensor,
a. Disconnect the connector (1).
b. Remove the screw (2).
c. Remove the compiler tray no paper sensor (3).
Figure 2 Compiler tray no paper sensor removal
Replacement
The replacement is the reverse of the removal procedure.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Figure 2:

REP 13.29 Front/Rear Carriage Assembly

Parts List on PL 13.15
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Enter dC330, code 12-060 stacker motor up, to fully raise the stacker tray.
2. Remove the finisher front cover,REP
3. Remove the rear upper cover,
4. Remove the rear lower cover,
5. Remove the stacker tray, REP
6. Removing the carriage assembly,
a. Disconnect, then remove the spring (1).
b. Use a flat bladed screwdriver to release the belt clamp latch (2).aside and
c. Remove the stacker belt and carriage assembly.
NOTE: . The carriage bearings (2 each assembly) are not fastened to the shafts.
Ensure the bearings are retained when the carriage assembly is removed.
Figure 1 Carriage assembly removal
Replacement
Ensure that the front and rear carriage assemblies are installed at the same height.
The replacement is the reverse of the removal procedure.
April 2017
4-123
WARNING
GP 10. Disconnect the power cord
13.6.
REP 13.7.
REP 13.8.
13.20.
Figure 1:
CAUTION
Repairs and Adjustments
REP 13.28, REP 13.29