Rep 12.5 Front And Rear Jogger Assemblies - Xerox WorkCentre 4150 Service Manual

REP 12.5 Front and Rear Jogger Assemblies

Parts List on PL 12.30
Purpose
This procedure is used to repair the following components:
NOTE: Only perform the steps that are necessary to repair the damaged component.
• Compiler Assembly, PL 12.20 Item
• Front Jogger Assembly, PL 12.30 Item
• Rear Jogger Assembly, PL 12.30 Item
Repairs and Adjustments
REP 12.5
33.
27.
28.
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the Exit Roll (REP
2. Prepare to remove the Compiler Assembly
1
Remove 2 screws
marked A.
Figure 1 Preparing to Remove the Compiler Assembly
January 2016
4-170 WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
WARNING
WARNING
CAUTION
12.3).
(Figure 1).
4
Disconnect the
bulkhead connector.
3
Remove the
E-clip, then
the bearing.
2
Remove the
E-clip, then
the pulley.
GP 10.