Removing The Compiler No Paper Sensor (J0St41735); Removing The Carriage Assembly (J0St41717); Rep 16.2.27 Front/Rear Carriage Assembly - Xerox WorkCentre 5222 Service Manual

1
Discon-
nect the
connec-
tor
2
Remove
the screw
(1)
3
Remove
the Sen-
sor
Figure 2 Removing the Compiler No Paper Sensor (j0st41735)
Repairs and Adjustments
REP 16.2.26, REP 16.2.27

REP 16.2.27 Front/Rear Carriage Assembly

Parts List on PL 23.7
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
NOTE: Ensure that the Stacker Tray is in the top position.
1. Switch off the power and disconnect the power cord.
2. Remove the Finisher Front Cover.
3. Remove the Rear Upper and Rear Lower Covers.
4. Remove the Stacker Tray.
5. Removing the Carriage Assembly.
a. Disconnect and remove the Spring.
NOTE: The Carriage Bearings (2 each Assembly) are not fastened to the shafts. Use care to
catch the Bearings when the Carriage Assembly is removed.
b. With a 6 inch common screwdriver, move the belt Clamp latch aside and remove the
Stacker Belt and Carriage Assembly.
Figure 1 Removing the Carriage Assembly (j0st41717)
February, 2008
4-160
WARNING
(REP 16.2.2)
(REP 16.2.3, REP
(PL 23.7)
(Figure 1)
WorkCentre 5225, 5230
16.2.4)
1
Remove
the
Spring
2
Release
latch and
remove
Belt
3
Remove
the Car-
riage
Assem-
bly
Launch Version