Rep 8.3 Paper Transport Assembly - Xerox WorkCentre 4150 Service Manual

20. Remove the registration roll idler, Figure 11.
Figure 11 Registration roll idler removal
Replacement
1. Replacement is the reverse of the removal procedure.
2. The actuators are different. Ensure that they are installed correctly, refer to PL 8.15.
Repairs and Adjustments
REP 8.2, REP 8.3

REP 8.3 Paper Transport Assembly

Parts List on PL 8.20
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1
Remove the registration
Take care during this procedure. Sharp edges may be present that can cause injury.
roll idler.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Remove the registration roll, REP 8.2.
2. Prepare the rear of the paper transport assembly, Figure 1.
September 2006
4-36
WARNING
WARNING
CAUTION
2
Remove 1
screw, then the
1
bracket and
Disconnect the
bearing.
inline connector.
Figure 1 Preparation
WorkCentre 4150