Rep 13.1 H-Transport Assembly; Rep 13.2 Hole Punch Assembly - Xerox VersaLink B7025 Service Manual

REP 13.1 H-Transport Assembly

Parts List on PL 13.05
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Undock the finisher, REP 13.5.
2. Remove the H-transport assembly,
a. Disconnect the harness (1).
b. Remove two screws (2).
c. Remove the docking plate (3).
d. Remove the H-transport (4).
Figure 1 H-transport removal
Replacement
The replacement is the reverse of the removal procedure.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10. Disconnect the power cord
Figure 1:

REP 13.2 Hole Punch Assembly

Parts List on PL 13.06
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
NOTE: For clarity, the H-transport is shown removed from the machine in
1. Hold open the H-transport top cover.
2. Open the H-transport front cover.
3. Remove the hole punch assembly,
a. Release the cable clamp (1).
b. Remove the connector cover (2), then disconnect the connector.
c. Remove the thumbscrew (3).
d. Remove the hole punch assembly (4).
Figure 1 Hole punch assembly removal
April 2017
4-95
WARNING
GP 10. Disconnect the power cord
Figure
Figure 1:
Repairs and Adjustments
REP 13.1, REP 13.2
1.