Rep 16.1.1 H-Transport Assembly; Rep 16.1.2 Hole Punch Assembly - Xerox WorkCentre 5222 Service Manual

REP 16.1.1 H-Transport Assembly

Parts List on PL 23.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Undock the Finisher Assembly (REP
2. Move the H-Transport Assembly. (Figure
a. Disconnect the cable ties and the connector.
b. Remove the screw (1).
c. Remove the Docking Plate.
d. Remove the H-Transport Assembly.
4
3
Remove the H-Transport
Remove Docking Plate
Figure 1 Removing the Docking Bracket (j0st41662.jpg)
Replacement
1. To install, carry out the removal steps in reverse order.
Launch Version
WorkCentre 5225, 5230
WARNING
16.2.1)
1)
2
Remove the screws (1)

REP 16.1.2 Hole Punch Assembly

Parts List on PL 23.2
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Open the H-Transport Top Cover and hold it open.
2. Open the H-Transport Front Cover.
3. Remove the Hole Punch Assembly.
a. Disconnect the cable clamp.
b. Remove the Connector cover and disconnect the Connector
c. Remove the Thumb screw (1).
d. Lift the Hole Punch Assembly and pull outboard to remove.
1
Discon-
nect con-
nector
and
Cable
2
Remove the Connector Cover and
disconnect the connector
Figure 1 Removing the Hole Punch Assembly (j0st41663.jpg)
Replacement
1. Insert the Hole Punch Assembly rear locating pin into the H-Transport frame.
2. Install the Hole Punch Assembly in reverse order of removal.
February, 2008
4-131
WARNING
(Figure 1)
1
Disconnect the cable
clamp
Repairs and Adjustments
REP 16.1.1, REP 16.1.2
3
Remove
the
Thumb
Screw
Front
Cover
4
Remove
the Hole
Punch
Assem-
bly