Stacker Tray Assembly - Xerox DocuColor 12/DCCS50 Service Manual

REP 15.2.2 Stacker Tray Assembly
Parts List on PL 18.27
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Stapler Cover Assembly
3. Remove the Rear Lower Cover (REP
4. Remove the front wheel Caster Cap
5. Disconnect P/J1090, P/J1071, P/J1067
the harness clips.
6. Remove the Stacker Tray Assembly
1. Remove the screws (5) securing the Stacker Tray Assembly to the Finisher frame
front and rear.
2. Lift the Stacker Tray Assembly off the screws and remove the assembly from the
frame.
Figure 1 Remove the Stacker Tray Assembly
Replacement
1. Reinstall the Stacker Tray Assembly by hooking the keyhole screw holes at the middle of
the Assembly over the two screws on the frame.
2. Use two screws to secure the bottom of the Assembly to the frame.
Finisher/Sorter
REP 15.2.2
WARNING
(REP 15.3.3).
15.3.15).
(PL 18.4 item 8).
and P/J1064 and remove the wire harness from
(Figure 1).
3. Tighten the two middle screws.
4. Reconnect P/J1090, P/J1071,
5. Secure the wire harness into the harness clips.
6. Install the Front Wheel Caster Cap.
7. Install the Rear Lower Cover.
8. Install the Stapler Cover Assembly.
1/05
8d-80
manuals4you.com manuals4you.com
P/J1067 and P/J1064 (Figure 1).
DocuColor 12/DCCS50
Reissue