Clearing Interface Counters; Enhanced Validation Of Interface Ranges - Dell Force10 Z9000 Configuration Manual

Hide thumbs Also See for Force10 Z9000:
Table of Contents

Advertisement

The following counter-dependent applications are supported by Dell Networking OS:
Egress VLAN
Ingress VLAN
Next Hop 2
Next Hop 1
Egress ACLs
ILM
IP FLOW
IP ACL
IP FIB
L2 ACL
L2 FIB

Clearing Interface Counters

The counters in the show interfaces command are reset by the clear counters command. This command does not clear
the counters any SNMP program captures.
To clear the counters, use the following the command.
Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical interfaces or selected
ones. Without an interface specified, the command clears all interface counters.
EXEC Privilege mode
clear counters [interface] [vrrp [vrid] | learning-limit]
(OPTIONAL) Enter the following interface keywords and slot/port or number information:
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
– For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to 1. The port range is 0.
– For a port channel interface, enter the keywords port-channel then a number.
– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
– (OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword vrrp. Enter a number from 1 to 255 as
the vrid.
– (OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC learning limit on the
interface, enter the keywords learning-limit.
Example of the clear counters Command
When you enter this command, confirm that you want Dell Networking OS to clear the interface counters for that interface.
Dell#clear counters te 1/1
Clear counters on TenGigabitEthernet 1/1 [confirm]
Dell#

Enhanced Validation of Interface Ranges

This functionality is supported on the Z9000 platform.
You can avoid specifying spaces between the range of interfaces, separated by commas, that you configure by using the
interface range command. For example, if you enter a list of interface ranges, such as interface range fo 2/0-1,te
10/0,gi 3/0,fa 0/0, this configuration is considered valid. The comma-separated list is not required to be separated by spaces
312
Interfaces

Advertisement

Table of Contents
loading

Table of Contents