Clearing Interface Counters; Enhanced Validation Of Interface Ranges - Dell S6100 Configuration Manual

Hide thumbs Also See for S6100:

Table of Contents

The following counter-dependent applications are supported by Dell Networking OS:

Ingress VLAN

Clearing Interface Counters

The counters in the show interfaces command are reset by the clear counters command. This command does not clear the

counters any SNMP program captures.

To clear the counters, use the following the command.

Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical interfaces or selected ones.

Without an interface specified, the command clears all interface counters.

EXEC Privilege mode

clear counters [interface] [vrrp [vrid] | learning-limit]

(OPTIONAL) Enter the following interface keywords and slot/port or number information:

For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the stack/slot/port/subport information.

For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the stack/slot/port/subport information.

For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.

For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.

For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the stack/slot/port information.

For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port information.

For a port channel interface, enter the keywords port-channel then a number.

For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

(OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword vrrp. Enter a number from 1 to 255 as the

(OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC learning limit on the interface,

enter the keywords learning-limit.

Example of the clear counters Command

When you enter this command, confirm that you want Dell Networking OS to clear the interface counters for that interface.

Dell#clear counters te 1/1/1/1

Clear counters on TenGigabitEthernet 1/1/1/1 [confirm]

You can avoid specifying spaces between the range of interfaces, separated by commas, that you configure by using the interface

range command. For example, if you enter a list of interface ranges, such as interface range hu 1/1/1,fo 1/3/1, this