Enable Stp - Panasonic ZEQUO 2200 Operating Instructions Manual

54.8. config stp mst_config_id
 Description
This command is used to configure a configuration name or revision level in the MST
configuration identification. The default configuration name is the MAC address of the
bridge.
 Format
config stp mst_config_id {revision_level <int 0-65535> | name <string>} (1)
 Parameters
revision_level
Specify the revision level.
<int 0-65535>
Specify the revision level.
name Specify the name given for a specified MST region.
<string>
Specify the name given for a specified MST region.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To change the name and revision level of the MST configuration identification:
Zxxx0:admin#config stp mst_config_id revision_level 1 name R&D_BlockG
Commands: config stp mst_config_id revision_level 1 name R&D_BlockG
Success.
Zxxx0:admin#

54.9. enable stp

 Description
Although it is possible to modify to allow a user to enable STP per instance, CIST should be
enabled first before enabling other instances. When a user enables the CIST, all MSTIs will
be enabled automatically if FORCE_VERSION is set to MSTP and there is at least one VLAN
mapped to this instance.
54. Spanning Tree Protocol (STP) commands
533