Zxxx0:admin#config link_aggregation group_id 1 master_port 7 ports 5-7
Command: config link_aggregation group_id 1 master_port 7 ports 5-7
Success.
Zxxx0:admin#
35.4. config link_aggregation algorithm
Description
This command is used to configure the part of the packet examined by the Switching Hub
when selecting the egress port for transmitting load-sharing data.
If the load sharing algorithm is based on IP information and the packet is a non-IP packet, it
will be based on the source MAC.
If the load sharing algorithm is based on L4 information and the packet is not a TCP/UDP
packet:
1)If the packet is a non-IP packet, it will be based on the source MAC.
2)If the packet is an IP packet, it will use the default value of "0" for the TCP/UDP port. It
means that if it is not a TCP/UDP IP packet, it will deal with it the same as way as the
TCP/UDP packets, but just the TCP/UDP value is 0.
Format
config link_aggregation algorithm [mac_source | mac_destination | mac_source_dest |
ip_source | ip_destination | ip_source_dest | l4_src_port | l4_dest_port | l4_src_dest_port]
Parameters
mac_source
Indicates that the Switching Hub should examine the MAC source address.
mac_destination
Indicates that the Switching Hub should examine the MAC destination address.
mac_source_dest
Indicates that the Switching Hub should examine the MAC source and destination
address.
ip_source
Indicate that the Switching Hub should examine the IP source address.
ip_destination
Indicate that the Switching Hub should examine the IP destination address.
ip_source_dest
Indicate that the Switching Hub should examine the IP source and destination address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
35. Link Aggregation Commands
299