Table of Contents
Advertisement
5.13. config serial_port
Description
This command is used to configure the serial bit rate that will be used to communicate with
the management host and the auto logout time for idle connections.
Format
config serial_port {baud_rate [9600 | 19200 | 38400 | 9600] | auto_logout [never |
2_minutes | 5_minutes | 10_minutes | 15_minutes]}(1)
Parameters
baud_rate
Specify the baud rate value. The default baud rate is 9600.
9600 Specify a baud rate of 9600.
19200
Specify a baud rate of 19200.
38400
Specify a baud rate of 38400.
115200
Specify a baud rate of 115200.
auto_logout
Specify the timeout value. The default timeout is 10_minutes.
never Specify to never timeout.
2_minutes
Specify when the idle value is over 2 minutes, the device will auto logout.
5_minutes
Specify when the idle value is over 5 minutes, the device will auto logout.
10_minutes
Specify when the idle value is over 10 minutes, the device will auto logout.
15_minutes
Specify when the idle value is over 15 minutes, the device will auto logout.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the baud rate:
Zxxx0:admin# config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
Zxxx0:admin#
5. Basic Management Commands
39
Advertisement
Table of Contents
