Panasonic ZEQUO 2200 Operating Instructions Manual page 401

44.7. config snmp system_name
 Description
This command is used to configure the SNMP system name of the Switching Hub.
 Format
config snmp system_name <sw_name>
 Parameters
<sw_name>
Specify an SNMP system name for the Switching Hub. A maximum of 255 characters is
allowed.
 Restrictions
Only Administrator and Operator-level users can issue this command.
 Example
To configure the Switching Hub SNMP name for "Zxxx0 Gigabit Ethernet Switch":
Zxxx0:admin# config snmp system_name Zxxx0 Gigabit Ethernet Switch
Command: config snmp system_name Zxxx0 Gigabit Ethernet Switch
Success.
Zxxx0:admin#
44.8. config snmp system_location
 Description
This command is used to enter a description of the SNMP system location of the Switching
Hub. A maximum of 255 characters can be used.
 Format
config snmp system_location <sw_location>
 Parameters
<sw_location>
Specify an SNMP system location for the Switching Hub. A maximum of 255 characters is
allowed.
44. Network Management Commands
401