50. QoS Commands
Zxxx0:admin#config dscp trust 1-8 state enable
Command: config dscp trust 1-8 state enable
Success.
Zxxx0:admin#
50.18. show dscp map
Description
This command is used to show DSCP trusted port list and mapped color, priority and
DSCP.
Format
show dscp map {<portlist>} [dscp_priority | dscp_dscp] {dscp <dscp_list>}
Parameters
<portlist>
(Optional) A range of ports to show. If no parameter is specified, all ports' dscp
mapping will be displayed.
dscp_priority
Specify a list of DSCP value to be mapped to a specific priority.
dscp_dscp
Specify a list of DSCP value to be mapped to a specific DSCP.
dscp
(Optional) This specifies DSCP value that will be mapped.
<dscp_list>
Enter the DSCP list here.
Restrictions
None.
Example
In case of project support per port configure, show DSCP map configuration on port
1:1.
480