Port Security Commands - Panasonic ZEQUO 2200 Operating Instructions Manual

47. Port Security Commands

47.Port Security Commands
Port security is used to limit the number of MAC addresses learned in
this Switching Hub to limit the number of terminals to be accessed. If
the specified number of terminals to be accessed is exceeded, exceeded
accesses are discarded.
You can configure the number of terminals based on the following
four levels.
 Entire system

For a port
 For a VLAN

For a port within a specific VLAN
config port_security ports [<portlist> | all] [{admin_state [enable | disable] | max_learning_addr
<max_lock_no 0-3328> | lock_address_mode [permanent | deleteontimeout |
deleteonreset]}(1) | {vlan [<vlan_name 32> | vlanid <vidlist>] max_learning_addr
[<max_lock_no 0-3328> | no_limit]}]
config port_security system max_learning_addr [<max_lock_no 1-3328> | no_limit]
config port_security vlan [<vlan_name 32> | vlanid <vidlist>] max_learning_addr [<max_lock_no 0-
3328> | no_limit]
delete port_security_entry [vlan <vlan_name 32> | vlanid <vlanid 1-4094>] mac_address
<macaddr>
clear port_security_entry {ports [<portlist> | all] | {[vlan <vlan_name 32> | vlanid <vidlist>]}}
show port_security_entry {ports {<portlist>} {[vlan <vlan_name 32> | vlanid <vidlist>]}}
show port_security {ports {<portlist>} {[vlan <vlan_name 32> | vlanid <vidlist>]}}
enable port_security trap_log
disable port_security trap_log
47.1. config port_security ports
 Description
This command is used to set the port's state, maximum supported MAC address
entries, the default entry type, and set the maximum port-security entries that can be
learned with a specific VLAN on a specific port. There are four levels of limitations on
the learned entry number, for the entire system, for a port, for a VLAN, and for
specific VLAN on a port. If any limitation is exceeded, the new entry will be discarded.
442