Panasonic ZEQUO 2200 Operating Instructions Manual page 124

16. Network Access Authentication Command List
 Parameters
<portlist>Enter the list of ports to be configured here.
all Specify all ports on the Switch.
auth_mode
(Optional) Specify the authentication mode used.
port_based
If one of the attached hosts passes the authentication, all hosts on the same port
will be granted to access network. If the user fails to authorize, this port will keep
trying the next authentication
host_based
Every user can be authenticated individually. v2.01 and later, can authenticate
client on specific authentication VLAN(s) only for WAC.
vlanid
(Optional) Specific authentication VLAN(s). This is useful when different
VLANs on the Switch have different authentication requirements.
<vidlist>
state
enable
disable
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
The following example sets the authorization mode and authentication VLAN for all ports.
Zxxx0:admin# config authentication ports all auth_mode host_based vlanid 1 state
enable
Command: config authentication ports all auth_mode host_based vlanid 1 state enable
Success.
Zxxx0:admin#
Enter the VLAN ID list here.
(Optional) Specify the VID list's authentication state.
Assign the specified VID list as authentication VLAN(s).
Remove the specified VID list from authentication VLAN(s). If "vlanid" is
not specified, or all VLANs is disabled, means do not care which VLAN
the client comes from, the client will be authenticated if the client's
MAC(not care the VLAN) is not authenticated. After the client is
authenticated, the client will not be re-authenticated when received
from other VLANs. All VLANs are disabled by default.
124