Panasonic ZEQUO 2200 Operating Instructions Manual page 282

33. Layer 2 Protocol Tunneling (L2PT) Command List
 Format
config l2protocol_tunnel ports [<portlist> | all] type [uni tunneled_protocol [{stp |
gvrp | protocol_mac [01-00-0C-CC-CC-CC | 01-00-0C-CC-CC-CD]}(1) | all] {threshold
<value 0-65535>} | nni | none]
 Parameters
ports Specify the ports on which the Layer 2 protocol tunneling will be configured.
<portlist>
Enter a list of ports to be configured here.
all Specify to use this configuration on all the ports.
type Specify the type of the ports.
uni Specify the port is UNI port
tunneled_protocol
Specify tunneled protocols on this UNI port. If specified all, all tunnel-able Layer 2
protocols will be tunneled on this port.
stp (Optional) Specify to use the STP protocol.
gvrp (Optional) Specify to use the GVRP protocol.
protocol_mac
(Optional) Specify which protocol MAC address to use.
01-00-0C-CC-CC-CCSpecify to use this protocol MAC address.
01-00-0C-CC-CC-CDSpecify to use this protocol MAC address.
all Specify to use all the MAC addresses.
threshold(Optional) Specify the drop threshold for packets-per-second accepted on this UNI port.
The port drops the PDU if the protocol's threshold is exceeded. The range of the threshold
value is 0 to 65535 (packet/second). The value 0 means on limit. By default, the value is
0.
<value 0-65535>
Enter the threshold packets-per-seconds value here. This value must be between 0
and 65535.
nni Specify the port is NNI port
none Disables tunnel on it. By default, a port is none port.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the STP tunneling on ports 1-4:
Zxxx0:admin# config l2protocol_tunnel ports 1-4 type uni tunneled_protocol stp
Command: config l2protocol_tunnel ports 1-4 type uni tunneled_protocol stp
Success.
Zxxx0:admin#
282