50. QoS Commands
Zxxx0:admin#show scheduling_mechanism 1-10
Command: show scheduling_mechanism 1-10
Port
Mode
-----
------
1
Strict
2
Strict
3
Strict
4
Strict
5
Strict
6
Strict
7
Strict
8
Strict
9
Strict
10
Strict
Zxxx0:admin#
50.9. config 802.1p user_priority
Description
This command is used to configure the way by which the Switching Hub will map an
incoming packet, based on its 802.1p user priority, to one of the eight available
hardware priority queues on the Switching Hub. The Switching Hub's default is to
map the following incoming 802.1p user priority values to the eight hardware priority
queues. The suggested mapping is shown in the following table. Users can change
this mapping by specifying the 802.1p user priority to assign to the <class_id>.
Priority in Frames
0
1
2
3
4
5
6
7
Format
config 802.1p user_priority {ports [<portlist> | all]} <priority 0-7> <class_id 0-7>
Parameters
<priority 0-7>
Specify the 802.1p user priority to associate with the <class_id> (the number of the
hardware queue).
Priority Queue of ASIC
2
0
1
3
4
5
6
7
472
Remark
Mid-Low
Lowest
Lowest
Mid-Low
Mid-High
Mid-High
Highest
Highest