Example
To show boot_file
Zxxx0:admin#show boot_file
Command: show boot_file
*1st Bootup Firmware
*1st Bootup Configuration
*Can not change 1st Bootup File
2nd Bootup Firmware
2nd Bootup Configuration
Actual Bootup Firmware
Actual Bootup Configuration
SD card: d drive, FLASH: c drive
Zxxx0:admin#
11.2. config boot_up command
Description
This command is used to config the boot_up command.
1. The parameter "<pathname>" can specifies file on either SD card or flash.
Pathname of the boot up file will be recorded in the system after issue the
commands above. And the 2nd boot up files can be shown by command "show
boot_file".
2. When use "config firmware image <pathname> boot_up" or "config configuration
<pathname> boot_up" commands, will check the file indicated by <pathname> is
existed or valid for boot up. If the file is not existed or not valid for boot up,
executing command will be failed.
nd
3. The 2
Bootup Firmware/Configuration will not be changed until using
command to configure it. That means it will not clear the 2
Configuration pathname when it is saved in SD card even though the SD card is
pushed out or insert SD card no this boot file or system is rebooted.
nd
4. For 2
Bootup Firmware or 2
up file should be: /c:/runtime.rom, /c:/config.cfg.
Format
config firmware image <pathname> boot_up
config configuration <pathname> boot_up
Parameters
None.
: /d:/sd_runtime.rom
: /d:/sd_config.cfg
: /c:/runtime.rom
: /c:/config.cfg
: /c:/runtime.rom
: /c:/config.cfg
nd
Bootup Configuration, the factory default boot
105
11. Bootup Function Commands
nd
Bootup Firmware/