Enable Ipif - Panasonic ZEQUO 2200 Operating Instructions Manual

 Parameters
<ipif_name 12>
The name of the interface.
ipv6address
The IPv6 network address to be deleted.
<ipv6networkaddr>
The IPv6 network address to be deleted.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To delete the IPv6 address:
Zxxx0:admin#delete ipif System ipv6address fc00::10/64
Command: delete ipif System ipv6address fc00::10/64
Success.
Zxxx0:admin#

10.3. enable ipif

 Description
This command is used to enable the state for an IPIF. When the state is enabled, the IPv4
processing will be started when an IPv4 address is configured on the IPIF. The IPv6
processing will be started when an IPv6 address is explicitly configured on the IPIF.
 Format
enable ipif <ipif_name 12> | all]
 Parameters
<ipif_name 12>
The name of the interface.
all All of the IP interfaces.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
97
10. Basic IP Commands