Panasonic ZEQUO 2200 Operating Instructions Manual page 267

Zxxx0:admin#show ipv6 neighbor_cache ipif System all
Command: show ipv6 neighbor_cache ipif System all
FE80::215:72FF:FE36:104
MAC Address : 00-15-72-36-01-04
Interface : System
Total Entries: 1
Zxxx0:admin#
30.4. config ipv6 nd ns ipif
 Description
This command is used to configure the NS retransmit time of a specified interface.
 Format
config ipv6 nd ns ipif <ipif_name 12> retrans_time <millisecond 0-4294967295>
 Parameters
<ipif_name 12>
Specify the name of the interface. The maximum length is 12 characters.
retrans_time
Specify the neighbor solicitation's retransmit timer in milliseconds. It has the same value
as ra retrans_time in the config ipv6 nd ra command. If one is configured, the other will
change too.
<millisecond 0-4294967295>
Specify the neighbor solicitation's retransmit timer in milliseconds. It has the same
value as ra retrans_time in the config ipv6 nd ra command. If one is configured, the
other will change too. Specify a time between 0 and 4294967295 milliseconds.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the NS retransmit time of a specified interface:
Zxxx0:admin#config ipv6 nd ns ipif System retrans_time 400
Command: config ipv6 nd ns ipif System retrans_time 400
Success.
Zxxx0:admin#
30. IPv6 NDP Commands
State: Reachable
Port : 1:21
VID : 1
267