Panasonic ZEQUO 2200 Operating Instructions Manual page 236

27. IGMP Snooping Commands
27.11. create igmp_snooping static_group
 Description
This command allows users to create an IGMP snooping static group. Member ports
can be added to the static group. The static member and the dynamic member port
form the member ports of a group. The static group will only take effect when IGMP
snooping is enabled on the VLAN. For those static member ports, the device needs to
emulate the IGMP protocol operation to the querier, and forward the traffic destined
to the multicast group to the member ports.
For a layer 3 device, the device is also responsible to route the packet destined for this
specific group to static member ports. The static member port will only affect V2
IGMP operation. The Reserved IP multicast address 224.0.0.X must be excluded from
the configured group.The VLAN must be created first before a static group can be
created.
 Format
create igmp_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>]
<ipaddr>
 Parameters
vlan Specify the name of the VLAN on which the router port resides.
<vlan_name 32>
Specify the VLAN name. The maximum length is 32 characters.
vlanid Specify the VLAN ID list.
<vlanid_list>
Specify the VLAN ID list.
<ipaddr>Specify the multicast group IP address (for Layer 3 Switching Hub).
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To create an IGMP snooping static group on default VLAN, group 239.1.1.1:
Zxxx0:admin#create igmp_snooping static_group vlan default 239.1.1.1
Command: create igmp_snooping static_group vlan default 239.1.1.1
Success.
Zxxx0:admin#
236