Panasonic ZEQUO 2200 Operating Instructions Manual page 556

57. Subnet VLAN Commands
57.1. create subnet_vlan
 Description
This command is used to create a subnet VLAN entry. A subnet VLAN entry is an IP
subnet-based VLAN classification rule. If an untagged or priority-tagged IP packet is
received on a port, its source IP address will be used to match the subnet VLAN
entries. If the source IP is in the subnet of an entry, the packet will be classified to the
VLAN defined for this subnet.
 Format
create subnet_vlan [network <network_address> | ipv6network <ipv6networkaddr>]
[vlan <vlan_name 32> | vlanid <vlanid 1-4094>] {priority <value 0-7>}
 Parameters
network Specify an IPv4 network address.
<network_address>
Specify an IPv4 network address. The format is ipaddress/prefix length.
ipv6network
Specify an IPv6 network address.
<ipv6networkaddr>
Specify an IPv6 network address. The format is ipaddress/prefix length. The prefix
length of IPv6 network address shall not be greater than 64.
vlan Specify a VLAN name to be associated with the subnet. The VLAN must be an existing
static VLAN.
<vlan_name 32>
Specify a VLAN name. The maximum length is 32 characters.
vlanid Specify the VLAN ID to be associated with the subnet. The VLAN must be an existing
static VLAN.
<vlanid 1-4094>
Specify the VLAN ID between 1 and 4094.
priority (Optional) Specify the priority to be associated with the subnet.
<value 0-7>
(Optional) Specify the priority to be associated with the subnet. The range is 0 to 7.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
556