Panasonic ZEQUO 2200 Operating Instructions Manual page 474

50. QoS Commands
 Example
To display the 802.1p user priority:
Zxxx0:admin#show 802.1p user_priority
Command: show 802.1p user_priority
QoS Class of Traffic
Port 1
Priority-0 ->
Priority-1 ->
Priority-2 ->
Priority-3 ->
Priority-4 ->
Priority-5 ->
Priority-6 ->
Priority-7 ->
Port 2
Priority-0 ->
Priority-1 ->
Priority-2 ->
Priority-3 ->
Priority-4 ->
Priority-5 ->
Priority-6 ->
Priority-7 ->
Zxxx0:admin#
50.11. config 802.1p default_priority
 Description
This command is used to specify default priority for untagged packets received on a
port of the Switching Hub.
 Format
config 802.1p default_priority [<portlist> | all ] <priority 0-7>
 Parameters
<portlist>
Specify a range of ports for which the default priority is to be configured. That is, a range
of ports for which all untagged packets received will be assigned the priority specified
below. The beginning and end of the port list range are separated by a dash.
all Specify that the command applies to all ports on the Switching Hub.
<priority 0-7>
Specify a priority value (0 to 7) to assign to untagged packets received by the Switching
Hub or a range of ports on the Switching Hub.
<Class-2>
<Class-0>
<Class-1>
<Class-3>
<Class-4>
<Class-5>
<Class-6>
<Class-7>
<Class-2>
<Class-0>
<Class-1>
<Class-3>
<Class-4>
<Class-5>
<Class-6>
<Class-7>
474