Panasonic ZEQUO 2200 Operating Instructions Manual page 345

 Parameters
<portlist>Specify a range of ports to configure the MAC-based access control settings
all Specify to select all the ports.
state Specify whether the MAC-based access control function is enabled or disabled.
enable
Specify to enable the MAC-based access control function.
disable
Specify to disable the MAC-based access control function.
aging_time
Specify a time period during which an authenticated host will be kept in the
authenticated state. When the aging time is timed-out, the host will be moved back to
unauthenticated state.
infinite
Specify an unlimited aging time.
<min 1-1440>
Specify the age-out time, in minutes, between 1 and 1440.
block_time
Specify the blocking time, in seconds, between 0 and 300.
<second 0-300>
Specify the blocking time. The blocking time value must be between 0 and 300
seconds.
max_users
Specify the number of maximum users. The default value is 1024 users.
<value 1-4000>
Specify the maximum number of users between 1 and 4000.
no_limit
Specify unlimitedly until 4000 of a maximum number of users.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the port state for ports 1 to 8:
Zxxx0:admin# config mac_based_access_control ports 1-8 state enable
Command: config mac_based_access_control ports 1-8 state enable
Success.
Zxxx0:admin#
39. MAC-based Access Control Commands
345