Panasonic ZEQUO 2200 Operating Instructions Manual page 237

27.12. config igmp_snooping static_group
 Description
This command is used to configure an IGMP snooping static group on the Switching
Hub. When a port is configured as a static member port, the IGMP protocol will not
operate on this port. Therefore, suppose that a port is a dynamic member port
learned by IGMP. If this port is configured as a static member later, then the IGMP
protocol will stop operating on this port. The IGMP protocol will resume once this
port is removed from static member ports. The static member port will only affect V2
IGMP operation.
 Format
config igmp_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>]
<ipaddr> [add | delete] <portlist>
 Parameters
vlan Specify the name of the VLAN on which the static group resides.
<vlan_name 32>
Specify the VLAN name. The maximum length is 32 characters.
vlanid Specify the ID of the VLAN on which the static group resides.
<vlanid_list>
Specify the VLAN ID list.
<ipaddr>Specify the multicast group IP address (for Layer 3 Switching Hub).
add Specify to add the member ports.
delete Specify to delete the member ports.
<portlist>Specify a range of ports to be configured.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To add port 9 to 10 to be IGMP snooping static member ports for group 239.1.1.1 on
default VLAN:
Zxxx0:admin#config igmp_snooping static_group vlan default 239.1.1.1 add 9-10
Command: config igmp_snooping static_group vlan default 239.1.1.1 add 9-10
Success.
Zxxx0:admin#
27. IGMP Snooping Commands
237