Panasonic ZEQUO 2200 Operating Instructions Manual page 64

6. Access Control List (ACL) Commands
tcp Specify TCP.
src_port
(Optional) Specify the TCP source port range.
<value 0-65535>
Specify the value between 0 and 65535.
mask (Optional) Specify the mask.
<hex 0x0-0xffff>
dst_port
(Optional) Specify the TCP destination port range.
<value 0-65535>
Specify the value between 0 and 65535.
mask (Optional) Specify the mask.
<hex 0x0-0xffff>
udp Specify UDP.
src_port
(Optional) Specify the UDP source port range.
<value 0-65535>
Specify the value between 0 and 65535.
mask (Optional) Specify the mask.
<hex 0x0-0xffff>
dst_port
(Optional) Specify the UDP destination port range.
<value 0-65535>
Specify the value between 0 and 65535.
mask Specify the mask.
<hex 0x0-0xffff>
icmp Specifies that the rule applies to the value of ICMP traffic.
type Specifies that the rule applies to the value of ICMP type traffic.
<value 0-255>
code Specifies that the rule applies to the value of ICMP code traffic.
<value 0-255>
port The access profile rule may be defined for each port on the Switching Hub. The port list is
specified by listing the lowest Switching Hub number and the beginning port number on
that Switching Hub, separated by a colon.
<portlist>
Specify a list of ports.
all Specify that the access rule will apply to all ports.
Specify the mask.
Specify the mask.
Specify the mask.
Specify the mask.
Enter the ICMP type value used here. This value must be between 0
and 255.
Enter the ICMP code value used here. This value must be between 0
and 255.
64