Enable/Disable Individual Trap - Panasonic M24PWR Operation Manual

4.6.3.c

Enable/Disable Individual Trap

On the SNMP Trap Receiver Configuration Menu screen, pressing "D" opens
the Enable/Disable Individual Trap Menu screen, as shown in Fig. 4-6-7. On
this screen, you can set the trap sending settings.
PN23249K/PN23249A Local Management System
SNMP Trap Receiver Configuration -> Enable/Disable Individual Trap Menu
SNMP Authentication Failure :
Enable Link Up/Down Port:
PoE Trap Control:
Temperature Trap Control:
Temperature Threshold:
FAN Failure:
-------------------------------- <COMMAND> -----------------------------------
Enable/Disable [A]uth Fail Trap
Add Link Up/Down Trap [P]orts
[D]elete Link Up/Down Trap Ports
Enable/Disable Po[E] Trap
Enable/Disable [T]emperature Trap
[S]et Temperature Threshold
Enable/Disable [F]AN Fail Trap
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Screen Description
SNMP Displays the trap sending settings for an SNMP authentication failure.
Authentication
Enabled
Failure
Disabled
Enabled Link Displays the port number to which a trap is sent, when its link status
Up/Down Port changes. All ports are assigned in factory default setting.
PoE Trap Displays the PoE trap control settings.
Control
Enabled
Disabled
Temperature Displays the trap sending settings when the internal temperature is
Trap Control above or below the preset temperature.
Enabled
Disabled
Temperature Displays the threshold temperature value to send the trap.
Threshold The factory default setting is 50 degress C.
FAN Failure Displays the trap sending settings for an internal fan failure.
Enabled
Disabled
Disabled
1-26
Enabled
Disabled
50 degree(s) Celsius
Enabled
Fig. 4-6-7 Enable/Disable Individual Trap
Enables the trap sending.
Disables the trap sending. (Factory default setting)
Enables the trap sending.
Disables the trap sending. (Factory default setting)
Enables the trap sending.
Disables the trap sending. (Factory default setting)
Enables the trap sending. (Factory default setting)
Disables the trap sending.
39