Panasonic ZEQUO 2200 Operating Instructions Manual page 659

Zxxx0:admin#config 802.1x fwd_pdu system enable
Command: config 802.1x fwd_pdu system enable
Success.
Zxxx0:admin#
67.11. config 802.1x auth_parameter ports
 Description
This command is used to configure the parameters that control the operation of the
authenticator associated with a port.
 Format
config 802.1x auth_parameter ports [<portlist> | all] [default | {direction [both | in] |
port_control [force_unauth | auto | force_auth] | quiet_period <sec 0-65535> |
tx_period <sec 1-65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-65535>
| max_req <value 1-10> | reauth_period <sec 1-65535> | max_users [<value 1-448> |
no_limit] | enable_reauth [enable | disable]}(1)]
 Parameters
<portlist>
Specify a range of ports to be configured.
all Specify to configure all ports.
default Set all parameters to the default value.
direction(Optional) Set the direction of access control.
both For bidirectional access control.
in For ingress access control.
port_control
(Optional) Force a specific port to be unconditionally authorized or unauthorized by
setting the parameter of port_control to be force_authorized or force_unauthorized.
Besides, the controlled port will reflect the outcome of authentication if port_control is
auto.
force_authorized
The port transmits and receives normal traffic without 802.1X-based
authentication of the client.
auto The port begins in the unauthorized state, and relays authentication messages
between the client and the authentication server.
force_unauthorized
The port will remain in the unauthorized state, ignoring all attempts by the client to
authenticate.
659
67. 802.1X Commands