Lacp Configuration Commands - Panasonic ZEQUO 2200 Operating Instructions Manual

32. LACP Configuration Commands

32.LACP Configuration Commands
Link aggregation is a technology to connect two Switching Hubs with
multiple ports and bundle them as one port. This provides path redundancy
and enhanced bandwidth.
LACP (Link Aggregate Control Protocol) is a protocol to automatically decide, set, and
monitor the port connection status in link aggregation.
The LACP operation mode needs to be configured for each port.

Active: Port sending LACP frames
 Passive: Port receiving LACP frames
For more information about how to enable link aggregation, refer to "Link
Aggregation Commands" section.
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
32.1. config lacp_port
 Description
This command is used to configure per-port LACP mode.
 Format
config lacp_port <portlist> mode [active | passive]
Figure 32-1 LACP overview
278