36. LLDP Commands
Example
To display LLDP TLV option port 1:
Zxxx0:admin#show lldp ports 1
Command: show lldp ports 1
Port ID
--------------------------------------------------------------
Admin Status
Notification Status
Advertised TLVs Option
Port Description
System Name
System Description
System Capabilities
Enabled Management Address
(None)
Port VLAN ID
Enabled Port_and_Protocol_VLAN_ID
(None)
Enabled VLAN Name
(None)
Enabled Protocol Identity
(None)
MAC/PHY Configuration/Status
Link Aggregation
Maximum Frame Size
Zxxx0:admin#
36.9. config lldp_med fast_start repeat_count
Description
This command is used to configure the fast start repeat count. When an LLDP-MED
Capabilities TLV is detected for an MSAP identifier not associated with an existing
LLDP remote system MIB, the application layer shall start the fast start mechanism
and set the 'medFastStart' timer to 'medFastStartRepeatCount' times 1. The default
value is 4.
Format
config lldp_med fast_start repeat_count <value 1-10>
Parameters
<value 1-10>
Specify a fast start repeat count value between 1 and 10. The default value is 4.
Restrictions
: 1
: TX_and_RX
: Disabled
:
316
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled