Panasonic ZEQUO 2200 Operating Instructions Manual page 456

49. Protocol VLAN Commands
delete protocol
Specify the protocol to be deleted. Depending on the frame type, the octet string will
have one of the following values below. The form of the input is 0x0 to 0xffff.
ethernet_2
This is a 16-bit (2-octet) hex value. Example: IPv4 is 800, IPv6 is 86dd, ARP is 806,
etc.
ieee802.3_snap
This is a 16-bit (2-octet) hex value. Example: IPv4 is 800, IPv6 is 86dd, ARP is 806,
etc.
ieee802.3_llc
This is the 2-octet IEEE 802.2 Link Service Access Point (LSAP) pair: first octet for
Destination Service Access Point (DSAP) and second octet for Source.
<protocol_value>
Specify the protocol value used to identify a protocol of the frame type. The form of the
input is 0x0 to 0xffff. Depending on the frame type, the octet string will have one of the
following values: For Ethernet II, this is a 16-bit (2-octet) hex value. For example, IPv4 is
800, IPv6 is 86dd, ARP is 806, etc. For IEEE802.3 SNAP, this is this is a 16-bit (2-octet) hex
value. For IEEE802.3 LLC, this is the 2-octet IEEE 802.2 Link Service Access Point (LSAP)
pair. The first octet is for Destination Service Access Point (DSAP) and the second octet is
for Source.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To add a protocol IPv6 to protocol group 4:
Zxxx0:admin# config dot1v_protocol_group group_id 4 add protocol ethernet_2 86dd
Command: config dot1v_protocol_group group_id 4 add protocol ethernet_2 86dd
Success.
Zxxx0:admin#
To delete a protocol IPv6 from protocol group ID 4:
Zxxx0:admin# config dot1v_protocol_group_group_id 4 delete protocol ethernet_2
86dd
Command: config dot1v_protocol_group group_id 4 delete protocol ethernet_2 86dd
Success.
Zxxx0:admin#
456