7.3.
config arpentry
Description
This command is used to configure a static entry in the ARP table. Specify the IP
address and MAC address of the entry.
Format
config arpentry <ipaddr> <macaddr>
Parameters
<ipaddr>The IP address of the end node or station.
<macaddr>
The MAC address corresponding to the IP address above.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a static ARP entry for the IP address 10.48.74.121 and MAC address
00:50:BA:00:07:36:
Zxxx0:admin#config arpentry 10.48.74.121 00-50-BA-00-07-36
Command: config arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
Zxxx0:admin#
7.4.
config arp_aging time
Description
This command is used to set the maximum amount of time, in minutes, that an ARP
entry can remain in the Switching Hub
is dropped from the table.
Format
config arp_aging time <min 0-65535>
s ARP table, without being accessed, before it
'
81
7. ARP Commands