Panasonic ZEQUO 2200 Operating Instructions Manual page 444

47. Port Security Commands
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure port security:
Zxxx0:admin#config port_security ports 6 admin_state enable max_learning_addr 10
lock_address_mode permanent
Command: config port_security ports 6 admin_state enable max_learning_addr 10
lock_address_mode permanent
Success.
Zxxx0:admin#
To configure a port security setting:
Zxxx0:admin#config port_security ports 1 vlan vlanid 1 max_learning_addr 16
Command: config port_security ports 1 vlan vlanid 1 max_learning_addr 16
Success.
Zxxx0:admin#
47.2. config port_security system
max_learning_addr
 Description
This command is used to set the maximum number of MAC address entries that can
be authorized system wide. There are four levels of limitations on the learned entry
number, for the entire system, for a port, for a VLAN, and for specific VLAN on a port.
If any limitation is exceeded, the new entry will be discarded. The setting for system
level max learned users must be greater than the total of the max learned users
allowed on all ports.
 Format
config port_security system max_learning_addr [<max_lock_no 1-3328> | no_limit]
444