Panasonic ZEQUO 2200 Operating Instructions Manual page 602

63. Utility Commands
 Example
To display the configuration file and firmware image assigned as a boot up file:
Zxxx0:admin#show boot_file
Command: show boot_file
Bootup Firmware
Bootup Configuration
Zxxx0:admin#
63.13. config rcp server
 Description
This command is used to configure Remote Copy Protocol (RCP) global server
information. This global RCP server setting can be used when the server or remote
user name is not specified. Only one RCP server can be configured for each system. If
a user does not specify the RCP server in the CLI command, and the global RCP server
was not configured, the Switching Hub will ask the user to input the server IP address
or remote user name while executing the RCP commands.
 Format
config rcp server {ipaddress <ipaddr> | username <username>}
 Parameters
ipaddress
(Optional) Specify the IP address of the global RCP server. By default, the server is
unspecified.
<ipaddr>
Specify the IP address of the RCP server.
username(Optional) Specify the remote user name on the RCP server.
<username>
Specify the remote user name on the RCP server.
 Restrictions
Only Administrator-level users can issue this command.
 Example
To configure RCP global server information for the username "travel":
: c:/runtime.rom
: c:/config.cfg
602