Network Monitoring Commands - Panasonic ZEQUO 2200 Operating Instructions Manual

45. Network Monitoring Commands

45.Network Monitoring Commands
The commands are used to display the following data for this Switching
Hub's operation status.

Counting the amount of transmission packets and error information for each port

Displaying the current port usage, CPU usage, DRAM usage, and flash usage
In addition, the following functions can be executed.
 Clearing the summary counter for each port

Displaying and configuring history log, system log and error log
show packet ports <portlist>
show error ports <portlist>
show utilization [ports | cpu]
show utilization dram {unit <unit_id>}
show utilization flash {unit <unit_id>}
clear counters {ports <portlist>}
clear log
show log {[index <value_list> | severity {module <module_list>} {emergency | alert | critical |
error | warning | notice | informational | debug | <level_list 0-7>} | module <module_list>]}
show log_save_timing
show log_software_module
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
enable syslog
disable syslog
show syslog
config syslog host [<index> | all] {severity [emergency | alert | critical | error | warning | notice |
informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 | local5
| local6 | local7] | udp_port <udp_port_number> | ipaddress [<ipaddr> | <ipv6addr>] | state
[enable | disable]}(1)
create syslog host <index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [emergency | alert |
critical | error | warning | notice | informational | debug | <level 0-7>] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
state [enable | disable]}
delete syslog host [<index 1-4> | all]
show syslog host {<index 1-4>}
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
show syslog source_ipif
show attack_log {index <value_list>}
clear attack_log
414