36. LLDP Commands
36.2. disable lldp
Description
This command is used to disable LLDP. The Switching Hub will stop the sending and
receiving of LLDP advertisement packets.
Format
disable lldp
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable LLDP:
Zxxx0:admin#disable lldp
Command: disable lldp
Success.
Zxxx0:admin#
36.3. config lldp
Description
This command is used to configure LLDP timer values. The message TX interval
controls how often active ports retransmit advertisements to their neighbors. The
message TX hold multiplier is a multiplier on the msgTxInterval that is used to
compute the TTL value of txTTL in an LLDPDU. The TTL will be carried in the LLDPDU
packet. The lifetime will be the minimum of 65535 and (message_tx_interval *
message_tx_hold_multiplier). On the partner Switching Hub, when the time-to-live
for a given advertisement expires, the advertised data is deleted from the neighbor
Switching Hub's MIB. The TX delay is used to change the minimum time (delay-
interval) any LLDP port will delay advertising successive LLDP advertisements due to a
change in LLDP MIB content. The TX delay defines the minimum interval between
sending of LLDP messages due to the constantly changing MIB content. A re-enabled
LLDP port will wait for the reinit delay after the last disable command before
reinitializing.
304