Config Dscp Map - Panasonic ZEQUO 2200 Operating Instructions Manual

50. QoS Commands
 Example
To display HOL prevention state on the Switching Hub:
Zxxx0:admin#show hol_prevention
Command: show hol_prevention
Device HOL Prevention State: Enabled
Zxxx0:admin#

50.16. config dscp map

 Description
This command is used to configure DSCP mapping. The mapping of DSCP to priority
will be used to determine the priority of the packet (which will be then used to
determine the scheduling queue) when the port is in DSCP trust state.
The mapping of DSCP to color will be used to determine the initial color of the packet
when the policing function of the packet is color aware and the packet is DSCP-
trusted.
The DSCP-to-DSCP mapping is used in the swap of DSCP of the packet when the
packet is ingresses to the port. The remaining processing of the packet will base on
the new DSCP. By default, the DSCP is mapped to the same DSCP.
These DSCP mapping will take effect at the same time when IP packet ingress from a
DSCP-trusted port.
 Format
config dscp map {[<portlist> | all]} [dscp_priority <dscp_list> to <priority 0-7> |
dscp_dscp <dscp_list> to <dscp 0-63>]
 Parameters
<portlist>
(Optional) Enter the list of port used for this configuration here.
all (Optional) Specify that all the ports will be included in this configuration.
dscp_priority
Specify a list of DSCP value to be mapped to a specific priority.
<dscp_list>
Enter the DSCP priority list here.
<priority 0-7>
Specify the result priority of mapping.
dscp_dscp
Specify a list of DSCP value to be mapped to a specific DSCP.
<dscp_list>
Enter the DSCP to DSCP list here.
<dscp 0-63>
Specify the result DSCP of mapping.
478