Panasonic ZEQUO 2200 Operating Instructions Manual page 143

17.7. config ddm ports state
 Description
This command is used to configure the DDM state and/or the DDM shutdown action when
it encounters an exceeding alarm or warning threshold event. The command configures
the DDM state and/or the DDM shutdown action when it encounters an exceeding alarm
or warning threshold event.
 Format
config ddm ports [<portlist> | all] { state [enable | disable] | shutdown [alarm | warning |
none] } (1)
 Parameters
ports
<portlist>
Specifies a range of ports to be configured. (The portlist format: UnitID: port
number).
all If 'all' parameter is chosen, all optic ports' operating parameters will be configured.
state Specifies the DDM state to enabled or disabled. If the state is disabled, no DDM action
will take effect.
shutdown
Specifies whether or not to shutdown the port when the operating parameter exceeds
the corresponding alarm threshold or warning threshold.
alarm
Shutdown the port when the configured alarm threshold range is exceeded.
warning
Shutdown the port when the configured warning threshold range is exceeded.
none
The port will never shutdown regardless if the threshold ranges are exceeded or
not.
The port being shutdown, cannot be recovered to normal operation
automatically, and needs to use the "config ports <portlist> state enable"
command to manually recover the port.
The shutdown action is none by default.
 Restrictions
Administrators and operators.
 Example
To configure port 21's actions associate with the alarm:
17. Didital Diagnostic Monitoring (DDM) Commands
143