Panasonic ZEQUO 2200 Operating Instructions Manual page 596

63. Utility Commands
 Parameters
username(Optional) Specify the remote user name on the RCP server.
<username>
Specify the remote user name on the RCP server.
<ipaddr>(Optional) Specify the IP address of the RCP server.
dest_file Specify the path name on the RCP server. Note: If a user specifies the relative file path,
the path search strategy will depend on the server system. For some systems, the current
user working directory will be searched first, followed by the environment paths.
<path_filename 64>
Specify the path name on the RCP server.
rcp: Specify the path name on the RCP server or local RCP client.
Syntax: rcp: username@ipaddr/directory/filename.
Example for full path: user_name@10.1.1.1/home/user_name/desxxxx.rom;
Example for relative path: user_name@10.1.1.1./desxxxx.rom;
Note: No spaces are allowed in the <string>.
<string 128>
Specify the path name on the RCP server or local RCP client.
Syntax: rcp: username@ipaddr/directory/filename.
Example for full path: user_name@10.1.1.1/home/user_name/desxxxx.rom;
Example for relative path: user_name@10.1.1.1./desxxxx.rom;
Note: No spaces are allowed in the <string>.
unit (Optional) Specifies which unit on the stacking system. If it is not specified, it refers to the
master unit.
<unit_id 1-4>
Enter the unit ID used here. This value must be between 1 and 4.
src_file (Optional) Specify the path name of the source file. If not specified, the bootup image on
the device will be uploaded.
<pathname>
Specify the path name of the source file.
 Restrictions
Only Administrator and Operator-level users can issue this command.
 Example
To upload firmware image to an RCP server:
Zxxx0:admin#upload firmware_toRCP rcp: rcp_user@172.18.212.106/Zxxx0.rom src_file
2.00.009.rom
Command: upload firmware_toRCP rcp: rcp_user@172.18.212.106/Zxxx0.rom src_file
2.00.009.rom
Connecting to server............... Done.
Upload firmware.................... Done.
Zxxx0:admin#
596