Panasonic ZEQUO 2200 Operating Instructions Manual page 313

dot3_tlvsAn individual port or group of ports to exclude one or more of IEEE 802.3
Organizationally Specific TLV data types from outbound LLDP advertisements.
all (Optional) Configure all of the TLV optional data types below.
mac_phy_configuration_status
(Optional) This TLV optional data type indicates that LLDP agent should transmit
"MAC/PHY configuration/status TLV." This type indicates it is possible for two
ends of an IEEE 802.3 link to be configured with different duplex and/or speed
settings and still establish some limited network connectivity. More precisely,
the information includes whether the port supports the auto-negotiation
function, whether the function is enabled, the auto-negotiated advertised
capability, and the operational MAU type. The default state is disabled.
link_aggregation
(Optional) This TLV optional data type indicates that LLDP agent should transmit
"Link Aggregation TLV." This type indicates the current link aggregation status
of IEEE 802.3 MACs. More precisely, the information should include whether
the port is capable of doing link aggregation, whether the port is aggregated in
an aggregated link, and the aggregated port ID. The default state is disabled.
maximum_frame_size
(Optional) This TLV optional data type indicates that LLDP agent should transmit
"Maximum-frame-size TLV." The default state is disabled.
enable Enable the configuration of an individual port or group of ports to exclude one
or more of IEEE 802.3 Organizationally Specific TLV data types from outbound
LLDP advertisements.
disable Disable the configuration of an individual port or group of ports to exclude one
or more of IEEE 802.3 Organizationally Specific TLV data types from outbound
LLDP advertisements.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To change the SNMP notification state of ports 1 to 5 to enable:
Zxxx0:admin#config lldp ports 1-5 notification enable
Command: config lldp ports 1-5 notification enable
Success.
Zxxx0:admin#
To configure the mode of ports 1 to 5 to transmit and receive:
Zxxx0:admin#config lldp ports 1-5 admin_status tx_and_rx
Command: config lldp ports 1-5 admin_status tx_and_rx
Success.
Zxxx0:admin#
313
36. LLDP Commands