Config Dst - Panasonic ZEQUO 2200 Operating Instructions Manual

61.7. config dst

 Description
This command is used to change Daylight Saving Time settings.
 Format
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-
sat> | s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-4,
last> | e_day <end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm>
| offset [30 | 60 | 90 | 120]} (9) | annual {s_date <start_date 1-31> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} (7) ]
 Parameters
disable Disable the DST of the Switching Hub.
repeatingSet the DST to repeating mode.
annual Configure the DST period.
s_week Configure the start week number of DST.
<start_week 1-4,last>
Configure the start week number of DST. The values are 1 to 4.
s_day Configure the start day number of DST.
<start_day sun-sat>
Configure the start day number of DST. The values are sun, mon, tue, wed, thu, fri
and sat.
s_mth Configure the start month number of DST.
<start_mth 1-12>
Configure the start month number of DST. The values are 1 to 12.
s_time Configure the start time of DST.
<start_time hh:mm>
Configure the start time in hh:mm of DST.
e_week Configure the end week number of DST.
<end_week 1-4,last>
Configure the end week number of DST. The values are 1 to 4.
e_day Configure the end day number of DST.
<end_day sun-sat>
Configure the end day number of DST. The values are sun, mon, tue, wed, thu, fri
and sat.
e_mth Configure the end month number of DST.
<end_mth 1-12>
Configure the end month number of DST. The values are 1 to 12.
e_time Configure the end time of DST.
<end_time hh:mm>
Configure the end time in hh:mm of DST.
61. Time and SNTP Commands
579