Table of Contents
Advertisement
4. Using Command Line Interface
There is no initial username or password. Just press the Enter key twice to display the CLI
input cursor - Zxxx0:admin#. This is the command line where all commands are input.
4.2.
Setting the Switching Hub's IP Address
Each Switching Hub must be assigned its own IP Address, which is used for
communication with an SNMP network manager or other TCP/IP application (for
example BOOTP, TFTP). The Switch's default IP address is 10.90.90.90. You can
change the default Switch IP address to meet the specification of your networking
address scheme.
The Switching Hub is also assigned a unique MAC address by the factory. This MAC
address cannot be changed, and can be found on the initial boot console screen -
shown below or the command show switch.
Boot Procedure
-------------------------------------------------------------------------------
Power On Self Test ........................................
MAC Address
: 00-01-02-03-04-00
H/W Version
: A1
Please Wait, Loading V1.0.x.xx Runtime Image ..............
UART init .................................................
Starting runtime image
Device Discovery ..........................................
Configuration init ........................................
The Switching Hub's MAC address can also be found in the Web management
program on the Device Information (Basic Settings) window on the Configuration
menu.
The IP address for the Switching Hub must be set before it can be managed with the
Web-based manager. The Switch IP address can be automatically set using BOOTP or
DHCP protocols, in which case the actual address assigned to the Switching Hub must
be known.
Starting at the command line prompt, enter the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x's represent the IP address to be assigned to the
IP interface named System and the y's represent the corresponding subnet mask.
Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x's
represent the IP address to be assigned to the IP interface named System and the z
represents the corresponding number of subnets in CIDR notation.
The IP interface named System on the Switch can be assigned an IP address and subnet
mask which can then be used to connect a management station to the Switching
Hub's Telnet agent.
V1.0.x.xx
20
100 %
100 %
100 %
100 %
100 %
Advertisement
Table of Contents
