Panasonic ZEQUO 2200 Operating Instructions Manual page 308

36. LLDP Commands
 Example
To enable LLDP forwarding messages:
Zxxx0:admin#config lldp forward_message enable
Command: config lldp forward_message enable
Success.
Zxxx0:admin#
36.6. config lldp notification_interval
 Description
This command is used to configure LLDP timer values. This will globally change the
interval between successive LLDP change notifications generated by the Switching
Hub.
 Format
config lldp notification_interval <sec 5-3600>
 Parameters
<sec 5-3600>
Specify the notification interval range is from 5 to 3600 seconds. The default setting is 5
seconds.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To change the notification interval to 10 seconds:
Zxxx0:admin#config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
Zxxx0:admin#
308