Table of Contents
Advertisement
58. Switch Port Commands
speed
Set port speed for the specified ports.
auto Set port speed to auto negotiation.
capability_advertised
Specifies that the capability will be advertised.
10_half
Set port speed to 10_half. The combo ports cannot set this option.
10_full
Set port speed to 10_full.
100_half
Set port speed to 100_half. The combo ports cannot set this option.
100_full
Set port speed to 100_full.
1000_full
Set port speed to 1000_full. When setting copper port speed to 1000_full,
users should specify master and slave mode in pair for 1000-BASE TX, and
leave the 1000_full without any master or slave setting for fiber.
master
(Optional) Set to master.
slave
(Optional) Set to slave.
auto_negotiation
Specifies that the auto-negotiation option will be configured.
restart_an
Specifies to restart the auto-negotiation process.
remote_fault_advertised
Specifies that the remote fault advertisement option will be configured.
disable
Specifies to disable remote fault advertisement.
offline
Specifies that a local device may indicate Offline prior to powering off,
running transmitter tests, or removing the local device from the active
configuration. If it is set and detected offline, it will advertise at the next
auto-negotiation. It interacted for 1000Mbps MAUs.
link_fault
Specifies that if set and local device was detected, a Link_Failure condition
indicated by the loss of synchronization, will advertise at the next auto-
negotiation. It interacted for 1000Mbps MAUs.
auto_negotiation_error
Specifies the resolution which precludes operation between a local device
and link partner advertised at the next auto-negotiation. It interacted for
1000Mbps MAUs.
flow_control
Turn on or turn off flow control on one or more ports by setting flow_control to enable or
disable. The default value is disable.
enable
Turn on flow control.
disable
Turn off flow control.
learning Turn on or turn off MAC address learning on one or more ports. The default value is
enable.
enable
Turn on MAC address learning.
disable
Turn off MAC address learning.
564
Advertisement
Table of Contents
