Panasonic ZEQUO 2200 Operating Instructions Manual page 463

config bandwidth_control [<portlist> | all] {rx_rate [no_limit | <value 64-10240000>] | tx_rate
[no_limit | <value 64-10240000>]}(1)
show bandwidth_control {<portlist>}
config per_queue bandwidth_control {ports [<portlist> | all]} <cos_id_list 0-7> {{min_rate
[no_limit | <value 64-10240000>]} max_rate [no_limit | <value 64-10240000>]}(1)
show per_queue bandwidth_control {<portlist>}
config scheduling {ports [<portlist> | all]} <class_id 0-7> [strict | weight <value 1-127>]
config scheduling_mechanism {ports [<portlist> | all]} [strict | wrr]
show scheduling {<portlist>}
show scheduling_mechanism {<portlist>}
config 802.1p user_priority <priority 0-7> <class_id 0-7>
show 802.1p user_priority
config 802.1p default_priority [<portlist> | all] <priority 0-7>
show 802.1p default_priority {<portlist>}
enable hol_prevention
disable hol_prevention
show hol_prevention
config dscp map {[<portlist> | all]} [dscp_priority <dscp_list> to <priority 0-7> | dscp_dscp
<dscp_list> to <dscp 0-63>]
config dscp trust [<portlist> | all] state [enable | disable]
show dscp map {<portlist>} [dscp_priority | dscp_dscp] {dscp <dscp_list>}
show dscp trust {<portlist>}
50.1. config bandwidth_control
 Description
This command is used to set the maximum limit for port bandwidth.
 Format
config bandwidth_control [<portlist> | all] {rx_rate [no_limit | <value 64-10240000>] |
tx_rate [no_limit | <value 64-10240000>]}(1)
 Parameters
<portlist>Specify a range of ports to be configured.
all Specify all ports.
rx_rate (Optional) Specify the limitation of receive data rate.
no_limit
Specify to indicate there is no limit on port rx bandwidth.
<value 64-10240000>
Specify an integer value from 64 to 10240000 to set a maximum limit in Kbits/
sec. The specified bandwidth limit may be equaled but not exceeded. This
exact logical limit or token value is hardware determined. Note: 1 Kbit = 1000
bits, 1 Gigabit = 1000*1000 Kbits.
The displayed value calculates value using as following the calculation
formula. The decimal point is suppressed. So, The set range is just keep on the
multiple of 64. Actual rate = (inputted rate/ 64) * 64.
463
50. QoS Commands