Panasonic ZEQUO 2200 Operating Instructions Manual page 530

54. Spanning Tree Protocol (STP) commands
 Example
Display the STP MST Config ID:
Zxxx0:admin#show stp mst_config_id
Command: show stp mst_config_id
Current MST Configuration Identification
----------------------------------------
Configuration Name : 00-22-22-22-22-00
MSTI ID Vid list
------- -----------
CIST 1-4094
Zxxx0:admin#
54.5. create stp instance_id
 Description
This command is used to create a new MST instance independent from the default
Instance: CIST (Instance 0). After creating the MST instance, a user needs to configure the
VLANs (using commands in 70-7), or the newly created MST instance will still be in a
disabled state.
 Format
create stp instance_id <value 1-64>
 Parameters
<value 1-64>
Specify the MSTP instance ID. Instance 0 represents a default instance CIST. This value
must be between 1 and 64.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To create an MSTP instance:
Zxxx0:admin#create stp instance_id 2
Command: create stp instance_id 2
Warning:There is no VLAN mapping to this instance_id!
Success.
Zxxx0:admin#
530
Revision Level :0