Panasonic ZEQUO 2200 Operating Instructions Manual page 146

17. Didital Diagnostic Monitoring (DDM) Commands
17.10. config ddm power_unit
 Description
This command is used to configure the unit of DDM TX/RX power. The command
configures the global unit of DDM TX/RX power.
 Format
config ddm power_unit [mw | dbm]
 Parameters
power_unit
Specifies the unit of DDM TX/RX power. If the unit has been set, the display message and
configure value of TX/RX power use the same unit.
The default unit is mW.
 Restrictions
Administrators and operators.
 Example
To configure the unit of DDM TX/RX power:
Zxxx0:admin# config ddm power_unit dbm
Command: config ddm power_unit dbm
Success.
Zxxx0:admin#
146