Config Syslog Host - Panasonic ZEQUO 2200 Operating Instructions Manual

45.15. config syslog host

 Description
This command is used to configure the syslog host configuration.
 Format
config syslog host [<index> | all] {severity [emergency | alert | critical | error | warning |
notice | informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 |
local4 | local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress[ <ipaddr> |
<ipv6addr>] | state [enable | disable]} (1)
 Parameters
<index> Specify the host index.
all Specify all hosts.
severity (Optional) Specify the severity level supported: emergency, alert, critical, error, warning,
notice, informational, or debug.
emergency
Specify emergency messages.
alert Specify alert messages.
critical
Specify critical messages.
error Specify error messages.
warning
Specify warning messages.
noticeSpecify notice messages.
informational
Specify informational messages.
debugSpecify debug messages.
<level 0-7>
Specify a level between 0 and 7.
facility Some of the operating system daemons and processes have been assigned facility values.
Processes and daemons that have not been explicitly assigned a facility may use any of
the"local use" facilities or they may use the "user-level" facility. Those facilities that have
been designated are shown in the following:
local0 User-defined facility.
local1 User-defined facility.
local2 User-defined facility.
local3 User-defined facility.
local4 User-defined facility.
local5 User-defined facility.
local6 User-defined facility.
local7 User-defined facility.
udp_port
Specify the UDP port number.
<udp_port_number>
Specify the UDP port number.
45. Network Monitoring Commands
427